Simulating cable disconnect on USB Host Shield 2.0

A MOSFET controlling VBUS

A MOSFET controlling VBUS

Today I want to show a simple USB Host Shield 2.0 modification which allows controlling power to USB peripheral. I learned this technique from Camille’s comment to one of digital camera USB control articles. In short, the idea was to cut VBUS connection between USB host and peripheral, simulating disconnect state. P-channel MOSFET, inserted into VBUS, worked as a switch. I designed this capability into USB Host Shield 2.0 but never needed the functionality therefore this useful feature was left undocumented. Recently I started working with very interesting Nikon P&S camera which can be turned on and off with VBUS power so I finally made this modification. It is very simple.

Take a look at the title picture (click on it to make it larger). The modification uses existing VBUS power select pads of the shield. Out of the box, the one labeled 5V is shorted with solder bridge. First step is to remove this bridge with a solder wick so both pads are clean.

It can be seen that a MOSFET in SOT-23 package fits nicely on those pads (I’m using FDN306P). Drain and source pins are soldered to VBUS and 5V, respectively, and gate, which hangs in the air, is routed to an unused digital pin via an 1M resistor. When digital pin is low the MOSFET conducts. When digital pin goes high the MOSFET switches off disconnecting VBUS from the peripheral.

If you are going to drive high-power peripherals, like digital cameras or phones, it is a good idea to add some capacitance to 5V. I’m using 220uF low-ESR organic polymer tantalum cap in 1210 package which fits nicely on 0.1″ spaced 5V and GND pins of the shield; an ordinary leaded 100-200uF aluminum capacitor will work as well.