Andrew Kroll and I were talking a lot about running USB Host Shield at higher SPI speeds. We were discussing one peculiar case of seemingly defective SPI master module and were needed full sized shield-compatible host board with fast SPI to check our theories when I realized that I have two Digilent ChipKIT Uno32 boards sitting in my ever expanding “to-do” pile of projects. I sent one to Andrew and soon he made a port which compiles under Digilent’s IDE and runs on chipKIT boards, although we only tested on Uno32 (rev.B).
It should be noted that another good candidate for the host board capable of high-speed SPI would be Arduino DUE. It is supported by the library and presumably runs at up to 24 MHz SPI speed with full-size shield. Incidentally, none of us have a DUE so we can’t test. Donations are gladly accepted.
The chipKIT support is currently in beta. At the moment, the only code example I have verified is Board QC routine – a program I’m using to test the shields before selling them to people. The port lives in xxxajk branch. Making other examples work should be a simple matter of (quoting Andrew) “including the right SPI.h”. Indeed, nothing in the library relies on SPI speed so increasing it would simply allow data to be sent faster.
In this article I will show how I modified a standard full size USB Host shield rev.2.0 to run on chipKIT Uno32 board at high SPI speed. I was able to run up to 20 MHz; unfortunately, the next available SPI rate on Uno32 is 40 MHz which is too high for the MAX3421E chip. The modded shield can be seen on a title picture (click on it to make it larger). Uno32 is 3.3V board; even though the inputs on PIC32 on-board MCU are 5V tolerant and it is likely possible to run the shield as-is I removed the level shifting ICs, which are unnecessary when interfacing the shield with 3.3V boards and could decrease error margin. Also, the RESET line on the ICSP connector on Uno32 has been replaced with CS by Uno32 designer, perhaps to make it look more like SPI, so I also needed to disconnect and reroute it. Here is the implementation, step-by-step.
Continue reading Running USB Host code on Digilent chipKIT board